Dylby Roo recycling project,

Hi everyone. I thought that I had finished the structural work on Dylby Roo
But unfortunately I haven’t ,

I remembered that ages ago a man from the Mornington Peninsula had given me a ski pole for my project,
So I dug it out of its resting place ,
held it in position and thought
Hmm

No
It would be too low and it wouldn’t clear the engine  so i figured,
how to plug the hole?

Theres quite a few ways one can fix the hole .

Timber frame and sheet it with marine ply ,

Timber sleepers laminated together .

I chose layers of marine ply , screwed down with long stainless steel screws on a bed of chopstrand resin sarutated fibreglass mat .

So I got a sheet of marine ply 18mm the other day ,
as when you work on a boat marine ply is the same as normal  plywood but the glue is waterproof.
So it pays to use the correct application on every boat job  one undertakes .

So Blacks set up-a long aluminium straight
Edge so-we could rip a cut of a 100 off the edge ,
We did this twice .

Then Blacks cut them with their angles and I labled them ready for the next step .

The ski pole just needsa stay on it attached to the top of the teamsome and it will be all sorted .

Im looking foward to making my laminate and marrying it all in together and showing you how I have chosen  to do it for the ultimate possible  strength  ,

So stay tuned

Cheers xxx
Curlyg 0